8/5/2023 0 Comments Garmin mapinstall manualMapInstall supports nMaps (more than one supplemental map), without having to manually rename gmapsupp.img. MapInstall should also be faster in image creation and transfer (depending on the type of map and device) because of performance improvements we made. However, if you launch MapInstall from BaseCamp with data on the device, we will auto-select the tiles that you need to cover the data on the device (the data is also shown in MapInstall). It's not as helpful if you have several devices that you want the same selection for. So you could install one set of tiles, then reconnect the device and add or subtract some easily. MapInstall does read which maps you have installed on the device and draws them on the map. The ability to save map sets is an interesting feature, but is not currently supported by MapInstall. If something is wrong with a map on a device (mainly with routing) and you created the image with MapSource, I'd try again with MapInstall to at least eliminate one possible point of failure. So the official recommendation is to use MapInstall, not MapSource. They have been dozens of fixes since MapSource 6.16.3 was released. It might or might not work properly on the device. I want to point out that the image creation code in MapSource is very dated. It's fine to use MapSource if you want, but do so at your own risk. Ĭlick Finder > Documents > TomTom > HOME > Backup > Backup01. Ĭlick the Windows Start button and then click My Computer. Ĭlick the Windows Start button and then click My Documents. Open the following folder: TomTom > HOME > FromDevice. Open the following folder: TomTom > HOME > Download > complete > map. If you did not make a backup of your device, but you have downloaded the map before using TomTom HOME or copied it to your computer, you can use one of the following steps. Ĭlick the Windows Start button and then click Computer. Open the following folder: TomTom > HOME > Backup > Backup01. Ĭlick the Windows Start button and then click Documents. Open the following folder: Documents > TomTom > HOME > FromDevice. Right-click on the new folder and click Copy. ZIP and extract it to the same folder as in the previous step. ZIP, for instance Europe or United_Kingdom_and_Republic_of_Ireland. Name the new folder exactly the same as the. You see a folder with the name of the map you were trying to install, for instance Europe or United_Kingdom_and_Republic_of_Ireland. Open the following folder: Documents > TomTom > HOME > Download > complete > map. Also, is the name of the map you were asked to install manually, for instance Europe. These instructions are for the built-in extraction program, so they could vary depending on the extraction program that is installed on your computer. Wait until the computer has finished copying the folder onto your TomTom navigation device. Right-click on the removable drive, which is your TomTom navigation device, and click Paste. Right-click on this map folder and click Copy. Open the folder InternalMemory or Storage Open the following folder: Documents > TomTom > HOME > Backup > Backup01. Press the Windows key+E to open the Windows file explorer. You can copy the map manually from a backup created in TomTom HOME. NOTE: Depending on the size of the map and speed of your computer, this can take up to a few hours to complete.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |